Is your PX07 high volume compressor a bit tired after years of faithful service? Breath life back into it with our rebuild/ upgrade kit.

Load Assist Kit for the Holden Colorado Rodeo 2012 Plus.

2503 Boss triple Airbag Complete 2500lb Extreme Series triple Bag Top and Bottom plate and stainless bolts. 12 countersunk stainless bolts

Fully Compressed - 85mm with 6mm ends fitted Max Diameter- 155mm (widest when fully compressed) Max height - 335mm Max working pressure 0-160psi Test pressure - 480psi Burst pressure - 600psi

Ideal for use with small-bore flexible tubing like the 1/4" diameter type found in our Boss Load Assist Kits and Onboard Air Systems.

In Cab Control unit for vehicles fitted with an onboard air system as well as Load Assist Kits.

px07 12volt compressor 3/4 hp engine 100% duty cycle

NEW RELEASE Light weight 700mm Braided Air Hose with 3/8" Flare Fitting

NEW RELEASE Light weight 1500 mm Braided Air Hose with 3/8" Flare Fitting

Load Assist Kit for the Toyota Landcruiser 4WD Leaf Rear (non V8).

Airbag Load Assist Kit for the Dodge Ram DS/DT 1500 2009 Coil Assist. (Sits next to coil) ****NOTE - WILL NOT FIT THE TRX 1500 MODELS****

Load Assist Kit for the Mitsubishi Triton 2016plus MQ

This kit is used to control Load Assist Kits from inside your cab without the need for a tank and electric valves. Simple installation and controls bags independently up and down Includes: 1 x PX-01 12V BOSS Air Compressor. 1 x Stamped stainless steel gauge panel. 2 x Pneumatic Push Buttons for dropping each bag. 1 x 12V momentary switch for compressor. 1 x BOSS 200psi Dual Needle back-lit Gauge. 10 meters of 1/4” J844 DOT Airbrake line. 2 x 1/4” push connect check valves. 3 x Y Connectors. 2 x T Connectors. 4 x 1/4” female push fittings for gauge and buttons. 10 x Cable Ties. Instruction Sheet.